Shure PGX Wireless Systems - Giving you the freedom to move!
PGX4 Wireless Receiver The Shure PGX4 receiver makes wireless setup a snap. With features like Automatic Frequency Selection and Automatic Transmitter Setup, the PGX4 offers the best in wireless to performers on the go. PGX1 Wireless Bodypack Transmitter Designed to meet the needs of traveling performers, the Shure PGX1 can be used with headworn, lavalier, or instrument microphones, or with guitars or basses. This is a durable, lightweight, low profile system designed for use when freedom of movement is necessity. The perfect solution for church, theatre, television, corporate A/V, and any other application where good sound and low visibility are required.
Pricing includes one of your choice from the following three microphones:
Headset Microphone (Avlex-beige) features a screw on replaceable cable with Shure belt-pack adapter and an acoustically transparent windscreen
WL93 Series Subminiature Condenser Lavalier Microphone with 4 ft (1.2m) cable in Black - economical omnidirectional, subminiature, lavalier, condenser microphones designed for general speech applications where a visually unobtrusive microphone is desirable
WL183 (Omnidirectional): Recommended for general purpose sound reinforcement, recording, or remote monitoring applications. Low handling noise. Pickup angle: 360 degrees
CONSUMER ALERT
Most users do not need a license to operate this wireless microphone system. Nevertheless, operating this microphone system without a license is subject to certain restrictions: the system may not cause harmful interference; it must operate at a low power level (not in excess of 50 milliwatts); and it has no protection from interference received from any other device. Purchasers should also be aware that the FCC is currently evaluating use of wireless microphone systems, and these rules are subject to change. For more information, call the FCC at 1-888-CALL-FCC (TTY: 1-888-TELL-FCC) or visit the FCC's wireless microphone website : www.fcc.gov/cgb/wirelessmicrophones
General Specifications
Frequency Range: 518-554 626-662 740-776 786-822 830-866MHz
Switchable Frequencies: 1440 Af Frequency Response: 40-18000Hz
Signal To Noise Ratio: >110dB
Compander System: HDX HDX
Pilot Tone: 32768kHz defeatable
Receiver
Operating Time: EK:>8h
Weight: EM: approx. 1100g EK: approx. 158g
Dimensions: EM: 212x145x38 EK: 82x64x24
Squelch: Low: 5dBµV Mid: 15dBµV Hi: 25dBµV
Nominal Peak Deviation: XLR: Bal.:-24 to +18dBu
Jack: Unbal.:-30 to +12dBu (adjustable in 6 dB-steps)
Current Consumption: EM: approx.200mA EK: approx.130mA
Power Supply: EM: 10.5-16V DC 12V nom. EK: 2.4V DC
Adjacent Channel Rejection: >65dB
Image Rejection: >70dB
Sensitivity: <2.5µV
Intermodulation Spacing: >65dB
Receiver Principle: EM: True Diversity
EK: Non-Diversity
Booster Dc Supply: None(only via antenna splitter ASP2)
Transmitter
Weight: SK:approx.158g
SKM:approx. 450g
SKP:approx. 195g
Power Supply: 2.4V DC
Dimensions: SK:82x64x24
SKM:d=50x225
SKP:105x43x43
Nominal Peak Deviation: Mic:1.8V eff.
Line:approx. 24Veff Operating Voltage: >8h Current
Consumption: <170mA <250µA Rf
Outputs: typ. 30mW
Input Impedance: Mic:10kOhm
Line:1MOhm
Max Sound Pressure Level: approx. 154dB
WL93 Series Subminiature Condenser Lavalier Microphone
| SPECIFICATIONS |
WL93 MICROPHONE (with standard test circuit shown in User Guide Figure 3) |
SM93 MICROPHONE (with preamplifier) |
| Type |
Condenser (electret bias) |
Condenser (electret bias) |
| Frequency Response |
50 to 20,000 Hz |
80 to 20,000 Hz, 12 dB/octave rolloff below 100 Hz |
view larger |
| Polar Pattern |
Omnidirectional, uniform with frequency |
Omnidirectional, uniform with frequency |
| Output Impedance |
3000 ohms |
Rated at 150 ohms (90 ohms actual) Recommended minimum load impedance: 800 ohms (May be used with loads as low as 150 ohms with reduced clipping level) |
Output Level (1 Pascal = 94 dB SPL) |
Open Circuit Voltage: -38 dBV/Pa (13 mV) |
Open Circuit Voltage: -43 dBV/Pa (7.0 mV) |
Output Clipping Level (at 1,000 Hz) |
0.25 V at 120 dB |
-18 dBV (0.13 V) minimum |
| Total Harmonic Distortion |
Less than 1% at 120 dB |
Less than 1% at 120 dB |
| Maximum SPL |
120 dB |
120 dB |
Dynamic Range (maximum SPL to A-weighted noise level) |
102 dB |
98 dB |
| Output Noise (equivalent SPL) |
18 dB typical, A-weighted |
22 dB typical, A-weighted 26 dB, weighted per DIN 45 405 |
| Hum Pickup (electromagnetic) |
N/A |
-4 dB equivalent SPL in a 1 mOe field (60 Hz) |
| Signal-to-Noise Ratio |
76 dB at 94 dB SPL (IEC 651) |
72 dB at 94 dB SPL (IEC 651) |
| Polarity |
Positive pressure on microphone diaphragm produces positive voltage on pins 3 and 4 with respect to pin 1 (ground)* |
Positive pressure on microphone diaphragm produces positive voltage on pin 2 relative to pin 3 of preamplifier output cable connector |
Recommended Operating Voltage |
2 to 10 V; 5 V nominal (pin 2 to pins 3 and 4) |
11 to 52 Vdc phantom. Protected against reverse voltage application |
| Current Drain |
40 microamps typical |
0.33 mA |
| Environmental Conditions |
Operating Temperatures: -18 to 57 degrees C (0 to 135 degrees F) Storage Temperatures: -29 to 74 degrees C (-20 to 165 degrees F) |
Operating Temperatures: -18 to 57 degrees C (0 to 135 degrees F) Storage Temperatures: -29 to 74 degrees C (-20 to 165 degrees F) |
| Cable |
Black 1.27 m (4.17 ft), attached, two-conductor, shielded, terminated by miniature connector type TA4F (WL93T: Tan 1.27 m [4.17 ft]) |
Black 1.27 m (4.17 ft), attached, two-conductor, shielded, terminated by miniature connector type (TA4F) |
| Case |
|
|
| Case |
Microphone: Black ABS thermoplastic case with stainless-steel-mesh grille |
Microphone: Black ABS thermoplastic case with stainless-steel-mesh grille Preamplifier: Steel case with non-reflective black finish, black�chrome belt clip |
| Net Weight |
Microphone: 16 g (0.57 oz) |
Microphone: 16 g (0.57 oz) Preamplifier: 118 g (4.17 oz) |
* Produces positive voltage at pin 2 of Shure wireless receiver three-pin connector.
WL183 (Omnidirectional) Micro-flex Lavalier Microphone:
- Type
- Condenser (electret bias)
-
- Frequency Response
- 50 to 17,000 Hz
-
- Output Impedance
- 1800 ohms
-
- Sensitivity (1 Pa = 94 dB SPL)
- WL183: -40.0 dBV/Pa
- WL184: -44.5 dBV/Pa
- WL185: -45.5 dBV/Pa
-
- Maximum Sound Pressure Level
- WL183: 125.0 dB SPL
- WL184: 129.5 dB SPL
- WL185: 130.5 dB SPL
-
- Output Noise (A-weighted)
- WL183: 22.5 dB SPL
- WL184: 27.0 dB SPL
- WL185: 28.0 dB SPL
-
- Dynamic Range
- 102.5 dB
-
- Polarity
- Positive pressure on diaphragm produces positive voltage on pins 3 and 4 relative to pin 1.
-
- Power Requirements
- Regulated nominal +5 Vdc (1.5 Vdc to 10 Vdc) provided at microphone connector pin 2 relative to pin 1 of a Shure wireless microphone transmitter.